Military Wiki
TKB-022PM
Type Assault rifle
Place of origin Soviet Union
Production history
Designer German A. Korobov
Designed 1960s
Produced 1962 (TKB-022PM No. 1)
1965 (TKB-022PM No. 2)
1968 (TKB-022PM5 No. 1)
Variants TKB-022PM No. 1
TKB-022PM No. 2
TKB-022PM5 No. 1
Specifications
Mass 2.8 kg (TKB-022PM No. 1)
2.34 kg (TKB-022PM No. 2)
Length 525 mm
Barrel length 415 mm, 16.3 inches overall

Cartridge 7.62 x 39 mm
5.6 x 39 mm
Rate of fire 560 rounds/min
Feed system 30-round magazine
Sights Iron sights

TKB-022PM No. 1 (ТКБ-022ПМ № 1), TKB-022PM No. 2 (ТКБ-022ПМ № 2) and TKB-022PM5 No. 1 (ТКБ-022ПМ5 № 1) were Soviet bullpup assault rifles, capable of fully automatic fire, chambered for the 7.62 x 39 mm round (TKB-022PM No. 1 and TKB-022PM No. 2) and the 5.6 x 39 mm round (TKB-022PM5 No. 1), developed by the small arms designer German A. Korobov in the 1960s.

The weapons were gas operated with annular gas piston located around the barrel and a vertically moving bolt, which made it possible to minimise the length of the receiver group. A U-shaped rammer/extractor was used to chamber and extract the cartridge by pushing it into the chamber where after discharge was pulled back from the chamber and again, upon feeding the new cartridge, pushed forward and slightly up into an ejection tube above the barrel where finally exiting above the muzzle. Due to this ejection mechanism it was possible to fire from both right and left arm positions.

These weapons had the best barrel length to overall length ratio among the assault rifles. Firing from an unstable position, the TKB-022PM No. 1 and the TKB-022PM No. 2 had a three times better accuracy than the AKM. The TKB-022PM5 No. 1 had a better accuracy than the AKM when fired from a hand in a lying position at a distance of 100 meters.

Although these assault rifles performed well, they were turned down by the Soviet army for being too radical at that time. Additionally, there were concerns about the displaced center of gravity to the tail end of the weapon and the durability of the weapon's plastic housing during prolonged operations under difficult conditions or during storage itself.

See also[]

References[]

External links[]

All or a portion of this article consists of text from Wikipedia, and is therefore Creative Commons Licensed under GFDL.
The original article can be found at TKB-022PM and the edit history here.