M3 Bradley

M3 Bradley Cavalry Fighting Vehicle
Two M3 Bradleys in the Persian Gulf War
Type	Reconnaissance vehicle
Place of origin	United States
Service history
Wars	Persian Gulf War Iraq War
Production history
Designer	FMC Corporation (M3(A0), M3A1), United Defense (M3A2, M3A3)
Specifications
Mass	25–30.5 short tons (23–28 tonnes)
Length	21.2–21.5 ft (6.45–6.55 m)
Width	126–129 in (320–328 cm)
Height	117 in (297 cm)
Crew	3 + 2 passengers
Armor	Steel, 5083 and 7039 aluminum
Main armament	25 mm M242 Chain Gun 1500 rounds (300 ready) Dual TOW Anti-Tank Missile Launcher 12 rounds (2 in launcher)
Secondary armament	7.62 mm M240C machine gun
Engine	Cummins VTA-903
Transmission	General Electric HMPT-500
Ground clearance	18 in (46 cm)
Fuel capacity	175–197 gal (662–746 L)
Operational range	Road: 250–300 mi (480–400 km)
Maximum speed	Top road speed: 35–41 mph (56–66 km/h) Top water speed: 4–4.5 mph (6.4–7.2 km/h)

The M3 Bradley Cavalry Fighting Vehicle (CFV) is an American tracked armored reconnaissance vehicle manufactured by BAE Systems Land and Armaments (formerly United Defense) based on the Bradley Fighting Vehicle family. The M3 CFV is used by heavy armored cavalry units in the U.S. Army.

History

The M3 Bradley CFV is very similar to the M2 Bradley IFV (Infantry Fighting Vehicle) and is fielded with the same powerful two-man 25mm Bushmaster Cannon turret with the coaxial 7.62mm machine gun. It only varies from the M2 in a few subtle ways and by role. The M3 is classified as an armored reconnaissance and scout vehicle and does away with the firing ports found in the M2 series. The M3 also carries more TOW missiles as well as more ammunition for its 25mm and 7.62mm guns. The Bradley family as a whole was originally intended to support the M113 Armored Personnel Carrier (APC), but ended up replacing it altogether. Today, the Bradley is fielded in conjunction with the M1 Abrams series of main battle tanks and often accompanies infantry squads into combat. In the 1991 Persian Gulf War, Bradleys and their powerful 25mm cannon / TOW anti-tank missile combination destroyed more enemy tanks than the M1 Abrams. Only three Bradleys were lost to enemy fire, however, at least 17 were lost to friendly fire. Improvements to the Bradley family have included enhanced identification features, as well as anti-tank missile countermeasures (for first generation wire-guided missiles only) and improved armor protection in the form of ERA.

Replacement

It is the U.S. Army's intention that the BCT Ground Combat Vehicle Program will replace the M2 Bradley and M113 with the GCV Infantry Fighting Vehicle by 2018. The M3 Bradley could later be replaced by future variants of the GCV.

Design

Camouflage

The M3 Bradley comes in sand, woodland, olive drab, urban.

Concealment

All versions are equipped with two four-barreled M257 grenade launchers on the front of the turret for creating defensive smoke screens, chaff, and flares. It is also fitted with an engine smoke-generating system.

Armor

Armor for the hull and turret for all variants is steel, 5083 aluminum, and unique to the turret is 7039 aluminum. In addition the turret is strongly welded to the assembly.

NBC

The M3A1 variant introduced a gas particulate filter system.

Damage control

The M3A1 variant introduced a fire suppression system.

Mobility

The Bradley is highly capable in cross-country open terrain, in accordance with one of the main design objectives of keeping pace with the M1 Abrams Main Battle Tank. Whereas the M113 would float without much preparation, the Bradley was initially designed to float by deploying a flotation curtain around the vehicle. This caused some drownings due to failures during its first trials. Armor upgrades have negated this capability.^{[citation needed]} The M3 Bradley was originally developed to accommodate a scout motorcycle. The idea was abandoned when it became apparent that the cycle's unprotected fuel tank could be hazardous to crew members.

Variants

M3(A0)

This model is essentially a restowed M2 Bradley. The passenger compartment was occupied by two observers and more ammunition and missiles. Because it did not carry a squad, the firing ports were covered. The M3 retained the three periscopes between the cargo hatch and entry ramp and the periscopes along the sides of the vehicle.

M3A1

The M3A1 variant introduced a gas particulate filter system for NBC threats. Unlike the M2A1 Bradley, the NBC masks connected to the central filter for all five crewmen, instead of just the driver, gunner, and vehicle commander. This variant also introduced a fire suppression system. The three periscopes on the rear deck were omitted on the M3A1, and replaced by four periscopes in the cargo hatch itself. The two periscopes on the right side of the passenger compartment were also removed.

M3A2

The M3A2 incorporated enhanced armor upgrades, such as the ability to mount explosive reactive armor, from the M2A2 Bradley. After live fire testing, seating and ammunition stowage arrangements were also changed, with the observers moved to a bench on the left side of the vehicle and the missile stowage rearranged to enhance safety. After the Gulf War, other improvements including an eye-safe carbon dioxide laser rangefinder, global positioning system and compass, missile countermeasure device, combat identification system, and thermal viewer for the driver were incorporated into the M3A2-ODS.

M3A3

The M3A3 model of the Bradley uses enhanced information and communication equipment, a central processing unit, and information displays for the vehicle commander and squad leader. The M3A3 is compatible with the inter-vehicular communication system of the M1A2 Abrams tank and AH-64D Apache Longbow helicopter. The commander has an independent thermal viewer and a new integrated sight unit called the Improved Bradley Acquisition System (IBAS), which allows automatic gun adjustments, automatic boresighting, and tracking of dual targets. The roof is reinforced with titanium armor. Many M3A3s were converted from M3A2s.

References

• www.fas.org

External links

• www.fas.org