Military Wiki
Liberty truck
Liberty truck.jpg
Manufacturer Various
Production 17,093
Body and chassis
Class B 3 to 5 ton
Body style open cab, Cargo truck
Engine Gasoline, 425 Cu. In. L-head, 4-cycle, 52 Hp,
Transmission 4 speed, 4X2,
Wheelbase 160.5 In.
Length 261 In.
Width 84 In.
Height 75 In.
Curb weight 3/5 ton

The Liberty truck was a United States Army vehicle used in World War I.


The liberty truck was designed by the Motor Transport section of the Quartermaster Corps in cooperation with the members of the Society of Automotive Engineers. Production of the 3–5 ton truck began in 1917, and the first models appeared ten weeks after the design was standardized. Of the almost 9,500 produced by 15 manufacturers, more than 7,500 were sent overseas. The Liberty's four-speed transmission coupled with its 52-hp engine gave the truck a top speed of about 15 miles per hour (24 km/h).[1]

A "Liberty truck", the first standardized US army truck


  • Series I
    • Battery, generator and distributor with electrical lighting system, in addition to the independent magneto ignition
    • Distributor and magneto systems with independent sparkplugs and wires (two per cylinder)
    • Ball and coil spring device to hold starter crank up in front
    • Primarily wooden spoke wheels vs. more robust steel wheels but Steel wheels were issued on 1st variant in later production (reference photo of Indiana manufacturing plant storage lot)
    • Single clamp hold-down radiator cap threaded in the center into the radiator
    • Electric side lights
    • Electric Guide lights up front on the frame horn members inside wheel area
    • Electric tail lamp
    • Electrical troubleshooting lamp plug in dash
    • Dual ignition switch on dash for battery or magneto ignition
    • Ammeter in dash switch cluster (lights/battery/mag, the gauge and a plug socket for a trouble light)
    • Single dash-mounted fuel tank which gravity fed the carburetor
  • Series II
    • Magneto only, (distributor, battery, generator and electrical light systems removed)
    • Pressed steel spring clip to hold starting crank, vs. ball under spring clamp
    • Acetylene Gas illuminated spot/driving light in the center of the dashboard
    • Acetylene Gas illuminated side lights (possible transition from electric as they dropped the battery system)
    • Oil wick rear taillamp
    • Spring-mounted oil fill caps raised to vertical level for easier filling on suspension
    • Oil filler for engine moved to rear of block
    • Radiator uses flip-type cap with hinge to rear and lock bolts on the sides
    • Second fuel tank under passenger seat
    • Fuel tank hand pump on extreme right of cab for transferring fuel from the underseat mounted rear tank to primary dash mounted tank (co-driver job)

Surviving examples

  • There is one at the Fort Bliss museum,
  • One at the Fort Eustis, U.S. Army Transportation Museum
  • One at the National Museum of the United States Air Force Dayton, Ohio
  • One at the First Division Museum
  • One with Virginia Military Preservation Association [1] (W. Winget owner) in Virginia
  • One at the National Infantry Museum [2], Columbus, Georgia
  • One at the Oregon Military Museum.
  • One at the Iowa Military museum. [3]
  • One at the Allen County Museum, Lima, Ohio. [4]
  • One at the Camp Creek showgrounds near Waverly, Nebraska
  • One at the National Marine Corps Museum at Quantico. Triangle, Virginia
  • One at the Texas Military Forces Museum at Camp Mabry Austin, Texas
  • Two at the Lemay Family Collection Foundation Spanaway, Washington. [5]

See also


  1. "WWI STANDARD B "LIBERTY" TRUCK". National Museum of the US Air Force. Retrieved 2009-11-24. 
  • Army Motors number 100 (2002)

External links

This page uses Creative Commons Licensed content from Wikipedia (view authors).