Military Wiki
Register
Advertisement
AN/FPS-3, AN/FPS-20
AN-FPS-20 Radar
Bendix AN/FPS-20 radar
Country of origin United States
Type General Surveillance Radar
Frequency L-band
Pulse Repetition Frequency 440
Pulsewidth 4 µS
RPM 3.3, 5, 10 RPM
Power 750 kW x 2
Other Names AN/FPS-3, AN/MPS-7, AN/FPS-64, AN/FPS-65, AN/FPS-66, AN/FPS-67, AN/FPS-91, AN/FPS-93, AN/FPS-100, AN/FPS-113, AN/GPS-4, AN/FPS-508
AN-FPS-3 Radar

The FPS-3.

The AN/FPS-20 was a widely used L-band early warning and ground-controlled interception radar system used by the United States Air Force Air Defense Command, the Pinetree Line in Canada, and a variety of other users. The design started life as the Bendix AN/FPS-3 of 1950, which were upgraded to the FPS-20, and then spawned over a dozen different marques as various additional upgrades were applied. The FPS-20 formed the backbone of the US air defense network through the early Cold War with over 200 units deployed. Most FPS-20 sites were replaced by modern equipment in the late 1960s, although a number were turned over to the FAA, upgraded for air traffic control use, and became the ARSR-60.

The first AN/FPS-3 arrived in December 1950, and slated for installation at Eniwetok Atoll to control aircraft involved in the atomic bomb tests of early 1951.[1] Over the next few years, 48 FPS-3's were installed to replace the earlier systems in the Lashup Radar Network, and was also produced as the AN/MPS-7, a mobile version.[2] According to Winkler, the FPS-3 design was developed from the earlier CPS-5 design from Bell Labs and General Electric.[N 1] The system used two 5J26 magnetrons with 750 kW peak power operating at 1300 MHz and using a 400 pulse repetition frequency (prf) and 2 microsecond pulse width.[3] The antenna was driven at three fixed speeds of 3.3, 5 or 10 RPM, normally operating at 5. Many of the operating modules were mounted on the rotating platform, with the output signal fed via slip rings to amplifiers and displays at the base of the unit.

The FPS-3 was limited to about 55,000 feet (17 km) altitude, which was seen as a limitation in light of new jet-powered bombers known to be in development in the USSR. This led to the development of the AN/GPA-27 add-on unit, increasing the altitude to 65,000 feet (20 km).[N 2] Installations began in 1956.[2][N 3] New-build units from Bendix with this equipment pre-installed became the AN/FPS-20 of 1957.[N 4] Otherwise similar units with an antenna from General Electric were known as the AN/FPS-20B.

The FPS-20's were simple pulse-radar systems and subject to jamming using basic techniques. This led to a second series of upgrades to provide counter-jamming capabilities starting in 1959. Among these were the GPA-102 (MK-448) which turned an FPS-20 into the AN/FPS-64 and a FPS-20A to the AN/FPS-66, and the GPA-103 (MK-447) which turned a FPS-20 into the AN/FPS-65 and the FPS-20A to the AN/FPS-67.[4] Similar upgrades using a Canadian OA-4831 system produced the AN/FPS-87 and AN/FPS-87A. The BADGE 412-L upgrade of the FPS-20A created the AN/FPS-82.

A more major update was the MK-747, which added a new antenna from Raytheon, the Diplex Gating Unit (DGU), a bandpass filter and other modifications to produce the AN/FPS-91 and AN/FPS-91A. The similar MK-748 applied to the -60 series resulted in the AN/FPS-64A, -65A, -66A and -67A. Canadian AN/FPS-87's were also converted, becoming AN/FPS-93 and AN/FPS-93A. These units were used with the SAGE system.[5]

The FPS-20 was also widely used in Japan. They produced their own series of modifications, including a tunnel diode based amplifier and a separate receiver for the Airborne Instruments Laboratories system, producing the AN/FPS-20/20A JAPAN, or -J.

The Indian Air Force used the FPS-20 with a new digital moving target indicator (MTI) system from Bendix to create the AN/FPS-100 and FPS-100A. These systems were known as the "Blue Pearl", or Bendix Radar Processor BRP-150. These were remanufactured units with a new antenna, and included a new low-noise front-end amplifier. General Dynamics later produced a similar digital MTI system, producing the AN/FPS-113.

Notes[]

  1. radomes.org disputes the link with the CPS-5, which had a somewhat different antenna as can be seen in the photographs in Winkler's work. This confusion may be due to the language in Bacque, which refers to "newly developed AN/FPS-3 long-range radar set".
  2. The GPA-27 may be the slotted waveguide mounted on the top of the main antenna seen in images of the FPS-20. However, some images show this on radars labeled FPS-3, although this may be before they were renamed.
  3. Winkler refers to upgraded units as FPS-3B on page 76, but other sources agree with his own page 33 that these were actually called FPS-3A.
  4. Winkler does not mention this directly, but notes on page 77 that -3A units were also renamed FPS-20 when receiving updates.

References[]

Citations
Bibliography
Further reading
All or a portion of this article consists of text from Wikipedia, and is therefore Creative Commons Licensed under GFDL.
The original article can be found at Bendix AN/FPS-20 and the edit history here.
Advertisement