.480 Ruger | ||||||||
---|---|---|---|---|---|---|---|---|
File:475 Linebaugh and 480 Ruger cartridges.jpg .480 Ruger (on the left) and .475 Linebaugh cartridges | ||||||||
Type | Handgun | |||||||
Place of origin | USA | |||||||
Production history | ||||||||
Designer | Hornady / Sturm, Ruger | |||||||
Designed | 2003 | |||||||
Specifications | ||||||||
Parent cartridge | .475 Linebaugh | |||||||
Case type | Semi-rimmed, straight | |||||||
Bullet diameter | .475 in (12.1 mm) | |||||||
Neck diameter | .504 in (12.8 mm) | |||||||
Base diameter | .504 in (12.8 mm) | |||||||
Rim diameter | .540 in (13.7 mm) | |||||||
Rim thickness | .065 in (1.7 mm) | |||||||
Case length | 1.285 in (32.6 mm) | |||||||
Overall length | 1.650 in (41.9 mm) | |||||||
Primer type | Large pistol | |||||||
Maximum pressure | 48,000 psi (330 MPa) | |||||||
Ballistic performance
| ||||||||
Test barrel length: 7.5" Source(s): "Cartridges of the World"[1] |
The .480 Ruger is a revolver cartridge, introduced in 2003 by Sturm, Ruger and Hornady. This was the first new cartridge introduced by Ruger, and was at time of introduction the largest diameter production revolver cartridge, at .475 in (12.1 mm).
Design[]
.475 caliber handgun cartridges are not a new idea. The .475 Linebaugh was introduced around 1988 as a custom, 5 shot Ruger Blackhawk single action revolver. The .475 is a wildcat cartridge made by cutting the .45-70 case to a length of 1.5 inches (38 mm), and necking it to accept a .475 bullet. The .475 Linebaugh is an immensely powerful cartridge, more powerful than the .454 Casull, the most powerful production revolver cartridge at the time. The .475 diameter bullet allowed bullet weights over 400 grains (26 g), a feat not possible with the .45 caliber cartridge cases, and the terminal ballistics of the heavy bullet, even when loaded to moderate velocities, were impressive. The .475 Linebaugh was designed for handgun hunting of large game, such as bear, where deep penetration is required for a quick, humane kill, and the heavy, cast Keith style semiwadcutter bullets out of the .475 Linebaugh penetrated very well.[citation needed]
History[]
When Ruger began to design their new cartridge, they started with the .475 Linebaugh super-magnum cartridge, but went a different direction. Rather than using the Blackhawk, Ruger chose to chamber the new round in the double action Super Redhawk, and designed the cartridge to fit in a 6 shot cylinder. The Super Redhawk was already the only 6 shot .454 Casull revolver in production, as all other makers used 5 shot cylinders to keep the cylinder walls thicker to handle the high pressures. The .480 Ruger uses lower pressures than the .454 Casull at 48,000 PSI,[2] so the .454 Casull can produce higher velocities and more energy, although, with much lighter bullets than available in .475 caliber. The .480 case was also .21 inches shorter than the .475 Linebaugh, at 1.285 inches, the same as the .44 Magnum. The .45-70's large diameter rim is also turned down, which is required to fit the 6 cartridges in the Super Redhawk's cylinder without interference.
The .480 Ruger is often viewed by some, as a ".475 Special"; in other words, as a slightly downloaded version of the super-magnum cartridge. In fact, .480 Ruger rounds will fit and function in a .475 Linebaugh revolver, just as a .44 Special will fit and function in revolvers chambered for the .44 Magnum. Reviewing the .480's ballistics, however, reveals this is somewhat misleading, as this "Special" reference may cause one to consider the .480 as a low-powered target round, when in actuality it is much closer to its more powerful cousin, the .475 Linebaugh than the .44 Special is to the .44 Magnum. The .480 Ruger operates at a maximum pressure of 48,000 psi, whereas the Linebaugh has a maximum pressure of 50,000, showing how close indeed the two cartridges are. Depending on load, the .480 Ruger can easily reach within 150 ft/s (46 m/s) of the .475 Linebaugh, making it a very formidable hunting cartridge for large and dangerous game. The initial response to the .480 Ruger was mixed, as many reviewers compared it unfavorably to the more powerful .475 Linebaugh or .454 Casull, and wondered why Ruger had bothered to introduce a lower powered cartridge. (This was based on muzzle energy alone, with no regard to either bullet diameter or weight, or to TKO, as was evident in the sales literature and magazines of the times, which compared the new 325 gr load's muzzle energy to the muzzle energy of other handgun hunting cartridges.)[citation needed] Indeed, the first factory load, a 325-grain (21.1 g) bullet at 1,350 ft/s (410 m/s), is nearly within reach of the .44 Magnum. However, with bullets of 400 grains (26 g) and higher, the .480 Ruger starts to show more potential. The standard .44 Magnum powders, in similar amounts, will push a 400-grain (26 g) bullet at over 1300 ft/s (thus yielding a TKO factor around 35.28 vs. 34.62 for a 325 gr 454 Casull at 1,650 ft/s (500 m/s) ). This provides 1,500 ft·lbf (2,000 J). of muzzle energy, about 50% more than commercial .44 Magnum loads, showing the .480 Ruger's good efficiency with the heavy bullets. The lower velocities and lower pressures mean the .480 Ruger has less felt recoil and muzzle blast than the higher pressure super-magnums.
Usage[]
The .480 is a well-balanced cartridge, providing a lot of energy without the recoil of larger hard-kicking rounds. It has been stated by many gun writers, that the .44 Magnum is typically the most powerful handgun an average person can master. The .480 should be able to take that title, as its original Hornady loading of a 325gr JHP, easily surpasses factory loadings for the .44 Magnum, with very similar recoil in handguns of like weight.[1] The future of this round remains cloudy. Magazine articles and online forums were, for a brief while, replete with discussion about the potential of the cartridge.[citation needed] However, lackluster sales and a limited number of firearms available in this caliber have shown it to have only moderate popularity. Much of this may be due to the somewhat lackluster ballistics available from the initial Hornady factory offerings. Handloaders reported getting phenomenal performance out of the round rubbing shoulders with the .475 Linebaugh and easily equaling and even eclipsing the Taylor Knockout Value (TKO) of the .454 Casull, with less recoil, muzzle blast and noise due to the .480's lower pressures. Still, for the most part, the round was seen as not doing anything new and available loads limited its potential for the non-handloader to mere deer hunting (for which many calibers already exist to serve that need). There were many handgunners that disliked the heavy Super Redhawk, and waited for Ruger to release the cartridge in their Super Blackhawk single action. This never came to pass, so many potential buyers chose to just pass on the cartridge.
Also, recently Smith & Wesson introduced its .500 S&W and .460 S&W Magnum cartridges, the 480 has fallen even further into obscurity as it could not compete with the glitz of these new mega-cartridges.[citation needed] Revolvers chambered in .460 S&W Magnum can usually accept .454 Casull and .45 Colt rounds as well (in the same way that a .475 Linebaugh revolver can take .480 Ruger), a useful cost-saving feature that can increase the appeal of the .460 over the .480 for some shooters, especially for practice sessions where full-power rounds are not necessary.
See also[]
References[]
- ↑ 1.0 1.1 Barnes, Frank C. (2006) [1965]. Skinner, Stan. ed. Cartridges of the World (11th Edition ed.). Iola, WI, USA: Gun Digest Books. p. 313. ISBN 0-89689-297-2.
- ↑ "The .480 Ruger" by Chuck Hawks
- The .480 Ruger, in perspective at Handloads.com
- The .475 Linebaugh data from The Reload Bench
The original article can be found at .480 Ruger and the edit history here.